View Single Post
Old 2015.05.15, 08:26 PM   #9
rojak
Registered User
 
rojak's Avatar
 
Join Date: Jan 2015
Location: Malaysia
Posts: 36
Quote:
Originally Posted by cowboysir View Post
I have experienced a similar jerky acceleration with a PN motor (not as high a KV). With certain cells i will get great racing for 12-15 min but on other cells I get a bad "cogging" effect while trying to accelerate.

This seems to happen when i use all available throttle fwd on my endpoints adjustment.

I have corrected this for the most part by taking 10% off my total th-fwd endpoint.

It has been suggested to me that my wiring from esc to motor might be flawed slightly on one of the three wires...i have yet to check but you may find success with this in your case.

As for finger travelling a bit before getting any actual motor movement you might try creating a higher throttle curve on your TX...by ramping up the initial takeoff point you may have some success getting a quicker start from the motor. I have set 2 different brushed motors like this to great effect.
Hi,
What do you mean "creating a higher throttle curve"?Is it using ics?
rojak is offline   Reply With Quote