herman's 360gtc

[herman]

used it on the mr015 so i can use the inch up square bbs rims... i think it needs a bit more offset... but it seems ok...

[herman]

next 3...

[herman]

last three....

[Mazda787b]

I love that shell, it is the perfect compliment to my Yellow 575GTC!

[lfisminiz]

Looks good herman. Are you going to decal it up?

[herman]

hmmm .....

[Mojar7070]

Does the wheels rub onto the body??

[herman]

surprisingly not... the 360gtc originally uses a mr02 rm chassis...

i used a mr015 chassis for this body so i could use my square inch ups originally made for the mr01 chassis. although the square rims have some offset in the front and rear, they're still a bit short by a couple of millimeters, which makes it look like the rims don't quite fill in the wheel well...

i believe square has inch ups available for the mr02 chassis as well, but not quite sure as to what offsets they offer... hope this helps...

[Mojar7070]

In that case....Awesome car!! Those wheels fit under the wheel well perferctly. Where did you buy the wheels and how much were they??

[bolter9]

Originally Posted by herman

surprisingly not... the 360gtc originally uses a mr02 rm chassis...

i used a mr015 chassis for this body so i could use my square inch ups originally made for the mr01 chassis. although the square rims have some offset in the front and rear, they're still a bit short by a couple of millimeters, which makes it look like the rims don't quite fill in the wheel well...

i believe square has inch ups available for the mr02 chassis as well, but not quite sure as to what offsets they offer... hope this helps...

Yeah I tried my square inch ups (gold) with the same body mounted on an mr02...but the front wheels rubbed. What about the MR015 allows the inch ups to clear the body?

[HammerZ]

The MR015 is narrower up front like the MR01. It tucks the front wheels in more.

[joshsrchobbies]

Nice body . I like the red it looks awsome on that body .

Thanks,Josh

[bolter9]

Originally Posted by HammerZ

The MR015 is narrower up front like the MR01. It tucks the front wheels in more.

Cool, I was wondering if it'd fit that chassis, but since I don't have one, I wasn't sure.

thanks.

[herman]

Where did you buy the wheels and how much were they??

got them a long time ago... cost me an arm and a leg... you can try the shop on these forums if they still have them in stock...

[herman]

Yeah I tried my square inch ups (gold) with the same body mounted on an mr02...but the front wheels rubbed. What about the MR015 allows the inch ups to clear the body?

it depends... what kind of square inch ups do you have... are they made for the mr02? or mr015? the rims i got were specific for mr01, i put them on the mr015 since you can use some mr01 bodies on them, and as hammerz pointed out, the mr015 has a narrower front track width, which is quite simililar to the mr01.

if your square rims have some offset in the front, and you put them in the mr02, it would definitely stick out and rub the wheel wells/fender since the mr02 has a wider track width... solution?... get a mr015 ... or use a body that will compliment those beutiful rims... hope this helps...