installation:
if you want to retain the use of the stock springs.
tools needed:
cordless drill/dremel
.140-.155 drill ( allows kingpin to "lay over")
cartridge roll ( to grind off the top of the shock towers)
1. completely dis-assemble the fornt end
2. SLOWLY drill (.140-.155 drill)only the top of the shock tower, if you push too much you can/will break it completely off.
3. using the cartridge roll grind off the top of the shock tower approximately 1.5mm. if you go too far dont worry about it, the tension in the arms will keep the kingpin at the top. the only reason the tower is there is for the spring stop.
4. re-assemble in reverse order but the "C" clip goes on top of the new tower bar and the bar screws down in the factory location!
ADVANCED users:
i have discovered that if you completely remove the factory tower bars and only use the MantisWorx bars you can use the PN MR03 lowdown springs and have a better selection of springs. only thing required is a thin flat washer on top of the knuckle between the spring and thats it.
__________________
MantisWorx www.rcshox.com
professional RC products
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated.
The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year. Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All!
Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»