How do you recenter the steering servo? I have full radius steering, but the Tx steering trim needs to be all the way right for it to almost have straight steering. I tried a different Tx, but it has the same issue.
Is it possible to change the steering trim on the Tx? Could it be a PCB issue? It is very smooth, so I would think the pot is fine. Is this an issue when I should shim it? It is crazy that I have full steering, very smooth, but the trim is so far off that it is hard to drive even at full right trim.
Towards the top front of the chassis is a hole on top. You have to remove the top piece that connects the front suspension. Then use a small flat tip to center the car.
Here's how I do it.
Center the transmitter.
Center the chassis to track as straight as possible. Run the car forward and back adjusting as neccessary.
Make any small adjustments after with the transmitter.
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated.
The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year. Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All!
Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»