I'll have a few plates when available so motor swaps be done within min or so.
the chilli can face tat short compared to 130 atomic & pn cans which fit superb but with chilli the plate pulls away from can when tighten up plate retainer screw, so attempted to fit with screw loose then realised live terminal obstructed by pod an shaft. So have to get either T2 or Z2 as better fit with pod.
sounds like either the motor can is warped or if im reading this wrong could be the screw your using is to long and bottoming out on the can. not sure if you mean the screw that mounts the plate to the pod or the 2 screws that mount plate to pod
__________________
PN Racing
R1Wurks
LET's Go Racing
MBMZR
DG Designs
mount works tremendously thanks CT lap times have became quickier motor runs cooler.
I've tried install of chilli with plate screw loose an positive outcome so i'll drop some threadlock onto screw so won't back off anymore (hopes meshing be ok time shall tell)
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated.
The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year. Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All!
Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»