Is the option key for this product out yet? (Optional 0.5,1.5,2.0 and 2.5 deg Key).
Also how do you tell what caster angel the car is at? I noticed there is some of the caster plate showing in front or behind (depending on the orientation) the sliding camber arms if your looking above it. I'm assuming if you see the the plate in front of the arm is 4 caster?
For 2 degrees, when the front of the car is facing you, the bottom plate and the arm should be flush. When you have 4* of castor, the bottom plate should stick out a little bit when the front if the car is facing you.
hi guys. i just install this item on my mr 03. can anyone teach me how to use the key chamber?
sorry for such a dumb question.
i try to search the guide for this but apparently its gone already.
thx for the help
the small holes on the inside of the camber key represent the amount of camber, if theres's 2 holes then its's 2 degrees camber, :P
you need to detach your upper suspension arms, loosen the four screws at the top of the brace ,and you'll need to mount the hinge pin screw in the position you want them in on the camber key. Then mount the key on the chassis like this:
once it's in position you will ned to tighten the four upper screws before removing the tool.
can i ask if everyone installing this on top of the standard front cover?
i did that, just cutting the part where holding the pin, but i notice when i tighten all the screw, the bar will not be in a horizontal position (not straight).
any help? thx
Make sure the holes on the chassis itself don't have any burrs or irregularities. The chances of a defective base plate, while possible, are less likely than a deformed plastic chassis.
__________________
Cristian Tabush
REFLEX RACING USA
10 Time Mini-Z World Champions!!! http://www.reflexracing net
I do not see this product offered on the Reflex site anymore. Is it being distributed elsewhere or is discontinued and perhaps about to be replaced by a new product?
Last edited by CristianTabush; 2012.04.24 at 12:35 AM.
Reason: oops meant to hit quote...
I do not see this product offered on the Reflex site anymore. Is it being distributed elsewhere or is discontinued and perhaps about to be replaced by a new product?
It's just out of stock. We are hoping to get the new production in about 2 weeks. So sorry for the delay, our factory just takes too long these days. We are moving all our new product ventures to a different vendor as we speak. This way we can deliver new products much quicker.
__________________
Cristian Tabush
REFLEX RACING USA
10 Time Mini-Z World Champions!!! http://www.reflexracing net
Go to the manufactures section to Reflex Racing thread raised lower tower bar set for MR03 question page 2 and Cristian explains the reason for why a lot of mini z stuff is out of stock.
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated.
The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year. Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All!
Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»