Hello there. I was examining the brushless motor and electronics on my Micro-T, and it look's like they will fit the Lite! I don't want to hack up the one I currently have, so would need to get another Lite. Any thoughts to this? The brushless motor for the Micro-T look's like it'll fit right in to the Lite's motor housing, a custom mount may need to be made for it. Also, a look inside the Lite may fit the Spektrum 3500 receiver and brushless controller.
I will take pictures of the two side by side to show you what I mean.
Question is, steering servo. Any thoughts on this? Thanks!
Not too familiar with the lit setup and configuration, but from the experience of making a 2.4G AWD, it should not be that difficult to make a micro servo compatible to the Miniz servo setup. I'd suggest to check out two resources:
1) pchan0's 2.4G AWD on MA010 board
2) a thread about making a BET/AD band micro T (which tells you what should connect where on the BET board(lit AD band board).
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated.
The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year. Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All!
Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»