3d printing gears does not work very well at this small of a scale. Machined gears work best, and molded gears work ok. 3d printed gears have too low resolution to be fully accurate, and depending on process, they lack the durability. 3d printing is good for many applications, however, gears is not one of them. I tried 3d printing wheels, and the tolerances were not high enough for them to be good enough to use. Depending on orientation in the printer, you could have slightly oval wheels. That in a gear, would not be good.
I have access to a SLA 3D printer then we are at 0.01mm resolution if i use the max setting
Realistically, there should be almost no difference between having the rear spur installed or not. As long as it's not a considerable difference, it should be ok. It may need a little run in to break it in...
Run it for a few minutes, and check motor temps. If the motor is getting hot, then it may cause issues.
I wish I had access to a printer like that! I would have to learn more 3d design... But it would be fun to make some prototype parts.
__________________
EMUracing Micro RC Syndicate /DG Designs /GSR /Reflex Racing /Fast By Faqish /MurderTown Racing
Glad to hear that you have found resolution with the binding. Let us know how it is down the road. On the negative, modifying spur gears to fix it means that any change in gear ratio by spur will be a pain since you need to machine it...
__________________
EMUracing Micro RC Syndicate /DG Designs /GSR /Reflex Racing /Fast By Faqish /MurderTown Racing
Glad to hear that you have found resolution with the binding. Let us know how it is down the road. On the negative, modifying spur gears to fix it means that any change in gear ratio by spur will be a pain since you need to machine it...
I simply have to buy a set of spur for various gear ratio and machining it one time XD
also still have to see if the problem is only with 98mm wheelbase or also on other wheelbase setp
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated.
The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year. Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All!
Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»