Mini-Z, Kyosho Mini-Z Racer, MR-03, MR-02, MA-010, Forums, News, Pictures, Parts, and Shop - Mini-ZRacer.com
Forums, Mini-Z, MiniZ, Kyosho Mini-Z, Kyosho MiniZ, Kyosho Mini-Z Racer
Mini-Z Hop-Ups, Mini-Z Parts, MiniZ Hop-Ups, MiniZ Parts, Kyosho Mini-Z Hop-Ups, Kyosho Mini-Z Parts, Kyosho MiniZ Hop-Ups, Kyosho MiniZ Parts, Kyosho Mini-Z Racer Hop-Ups, Racer Kyosho Mini-Z Parts

Go Back   Mini-ZRacer.com Forums > General Discussion > Batteries, Chargers and Dischargers

Reply
 
Thread Tools Rate Thread Display Modes
Old 2016.01.25, 03:53 PM   #1
jevs
Registered User
 
Join Date: Jan 2016
Posts: 18
Charging single batteries vs. putting them in a pack? & Charger Recommendation

I just bought a couple Mini-z's and I am wondering about charging the batteries. I have a good charger that I use for everything else RC. It is an AC/DC Hitec X4 charger.

My question is if I should just get a battery holder that holds 4 AAA batteries and use this charger, charge each cell on each channel (pain), or buy a dedicated "round' battery charger.

I do have a couple chargers for round batteries, but I don't trust them enough for RC car batteries to do the best job.

If it is recommended to get another charger, I am looking at these:
SkyRC MC3000
SkyRC NC2500
Orion IQ-4X
PowerEx (Maha) MH-C9000

Anyone know of anything better, or which of these is the best?
jevs is offline   Reply With Quote
Old 2016.01.25, 05:40 PM   #2
cowboysir
epic procrastinator
 
Join Date: Jul 2006
Location: Whistler, B.C.
Posts: 2,156
I have both the Maha and the Hitec X4-AC.

because I have a lot of aaa cells I use both for specific reasons:

I use the Maha to get a base mA reading of the cell and match them all closest together in mA totals.

Once I have all my sets organized I use the Hitec with some inline 4xaaa cell holders to charge many sets at a time.

The Maha (or any of the single type chargers) will give you the maximum for each cell but when charging inline 4xaaa you will only get the charge total of the cell with the minimum mA total. (for example if you have 3 cells at 1000mA and one cell at 985mA the Hitec will stop charging at 985mA)

If you only are trying to organize a few sets or don't want to shell out $60 for a Maha you'd be perfectly fine using the Hitec and some sort of holder (I know guys that use old MR02 chassis as holders so you don't really need to go out and spend much on inline holders)
__________________
I wonder what rocket scientists say to their coworkers when one of them doesn't get it?

my custom body album (now that Photobucket sucks!)
http://mini-zracer.com/forums/album.php?albumid=192
cowboysir is offline   Reply With Quote
Old 2016.01.25, 05:44 PM   #3
lfisminiz
MINI-Z BODY NUT
 
lfisminiz's Avatar
 
Join Date: Mar 2003
Location: pa.
Posts: 5,027
If you decide to go with a dedicated AAA/AA charger, the Sky R.C. chargers are very good.
__________________
MINI-Z BODY NUT





DG DESIGNS - PN RACING - MANTISWORX
lfisminiz is offline   Reply With Quote
Old 2016.01.25, 06:05 PM   #4
Mike Keely
Registered User
 
Join Date: Sep 2008
Posts: 1,223
The SkyRC NC2500 and the Maha MH-C9000 are both good chargers. You can get the Maha's for $52 shipper on Flea Bay. I have a Maha that has been used every week for years with no problems.
__________________
DG-Designs / Brooklyn Hobbies
Mike Keely is offline   Reply With Quote
Old 2016.01.26, 01:51 PM   #5
RussF
Salt Lake Mini-Z
 
RussF's Avatar
 
Join Date: Jul 2002
Location: Salt Lake City Utah
Posts: 236
I use the Hitec X4 and 4 PN charging trays. Makes charging up 12 sets about a 1.5 - 2 hour job. I also have the PN discharger trays and they work great. I actually have 2 Hitec X4's, one with the ac built in for traveling and one DC version for home use. One bit of advise on charging with a separate tray for the cells is to make sure you use good wire leads from the charger to the tray. I had some crappy leads and they did all sorts of strange things to the batteries.
__________________
Salt Lake Mini-Z
RussF is offline   Reply With Quote
Old 2016.01.28, 10:13 AM   #6
littlebuddha
Registered User
 
Join Date: Mar 2014
Posts: 17
I had been pondering the same thing - and ended up getting a nimh charger as it is difficult to charge individual cells using the most standard rc multi-chargers- as there is no balance function like for lipo charges so even making a custom battery holder would not work (theoretically).

After quite a bit of research - I ended up getting the Opus BT-C700 - for less than $20 it has all the functions I need (charge/discharge/refresh/test) and is very small. And since I'll only be using it to charge aaa batteries for my minis - it fits the bill perfectly for me. I'm glad I did as I already found an undercharged cell that was causing my radio to flash low voltage.
littlebuddha is offline   Reply With Quote
Old 2016.01.28, 10:30 AM   #7
jevs
Registered User
 
Join Date: Jan 2016
Posts: 18
I ended up ordering the SkyRC MC3000 yesterday for $88 total with expedited shipping from China I guess. I found a coupon code. They also gave me a Cree LED flashlight.
I ordered 16 of the latest Eneloop Pro batteries using my Amazon Prime to get me started.
jevs is offline   Reply With Quote
Old 2016.03.09, 09:33 PM   #8
jevs
Registered User
 
Join Date: Jan 2016
Posts: 18
I tried it on a few batteries just using the simple mode to test it and it worked fine. I have not had time to do any RC since I got it though or spend any time really using it. It seems nice so far.

The flashlight I got for free works really well too! It is super bright and nice and has a nice white light. I was surprised for a free one. Blows those harbor freight ones away. It is blindingly bright if you shine it on someones face!
jevs is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
FS: Everything to sell- MR03 Cars, 10th Ed, Chargers, Radios, Tires, Batteries, Parts Ridetimelezz Mini-Z Marketplace 1 2013.09.11 11:28 AM
DNANO starter pack - perfex kt18, battery, charger assideways Mini-Z Marketplace 0 2013.07.11 09:38 AM
NEW PN Li-Po NiMH NiCd Charger coming soon! PNracing PN Racing 92 2012.08.22 01:10 AM
NiMH Battery Info G-Class Parts and Hop-ups 5 2004.09.09 10:29 AM
Lithium Monster!!...Review!! Hills Mini-Z Monster MM-01 19 2004.08.30 12:04 PM


All times are GMT -5. The time now is 06:21 PM.


Powered by vBulletin® Version 3.8.3
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2011 Mini-ZRacer.com
Mini Inferno Sale - Up to $85 Instant Savings!
Micro-T Hop-Ups
RC18R, M18, Micro RS4, Mini-LST, TamTech-Gear, Minizilla, RC18T, RC18B, RC18MT
shop.tinyrc.com Products

more»
Tiny RC Community News
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated. The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year.  Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All! Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»
Mini-Z, Mini-Z Racer, MR-02, MA-010
M18, M18T, RC18T, Mini-LST, Mini-T, Micro RS4, XRay, 1/18, 18th scale
XMODS, XMOD, Micro Flight, ZipZaps, ZipZaps SE, Bit Char-G, MicroSizers, TTTT, Plantraco Desktop Rover, SuperSlicks, Digi Q
Mini Inferno, Mini Inferno ST, half EIGHT, 1/16, 16th scale
Epoch, Indoor Racer, 1/43, 43rd scale
E-Savage, eSavage, eZilla, e-Zilla, HPI
Robots, Bots, Bipeds, Wheeled, Manoi, Roomba, NXT, Lego, Hacking
Crawling, Crawlers, Micro, RC, Losi Mini-Rock Crawler, Duratrax Cliff Climber
Kyosho Minium, Caliber 120, Minium Forums
Mini-Z Hop-Ups, Mini-Z Parts, Mini Inferno Hop-Ups, Mini Inferno Parts, M18 Hop-Ups, M18 Parts