I receive my new car and I setup the control With the manual but If I pull to full throttle the motor Stop.
I do not know what I need to move to correct this, any Help?.
1. basically raise your car off the ground (so it doesn't run off unsuspectedly) fiddle around with the throttle trim (press A/up) till the wheels start moving forward
2. then adjust throttle trim (press B/down) till the wheels stop, then press B a few more times until beeping sound from the chassis stops
3. finally press B 8 more times (might be 7,8,9 or more - i guess 8 is more or less the benchmark)
reverse should work a lot better now. almost like the am mr02 chassis...
you can use this method if your car is initially going in reverse - just press A till it goes forward. then go through the whole process again...
if it still doesn't work, try to reset the transmitter.
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated.
The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year. Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All!
Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»