I'm just setting up converting to the blue/grey SP chassis from the default AWD one, and also have the atomic titanium screw set (for the hex).
Now i've ran into a problem.
I've accounted for all the screws by just putting them in the parts that they will be needed in, but i am left with 0 for the front clip mount/ or the motor/board mount.
I've used the following:
The screws below are setup already, and are definately the right screws.
The screws below are potential screws, which all match what the old chassis was, and match the guide in the new chassis setup.
The screws below are the final screws which seem to be the correct ones, but then leaves me with no screws for the front clip.
Hopefully someone with some experience with these screws can guide me, as im well confused now, and i would have to buy another set of the screws just to get two for the front clip!
From what i can see, im assuming either try not to use some of the screws (eg rear plate changed with S.A.S would free up at least 4 screws), or perhaps the battery terminals with the original black screws, leaving the smaller ones for the front clip.
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated.
The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year. Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All!
Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»