Bought 2 pcs, one for mr03 the other one for awd.
MR03 working fine, can bind with my ex-5ur or kt18 same with AWD board too.
Throttle both board same, can be adjust via ics, only difference with steering response, AWD board i need to adjust the speed to lowest speed since it is hard to control.
By the way, both board I install on MR015 and MR02 body.
Just also just swapped out all the wiring/servo motor from an old Kyosho ASF MR03 board to the Dasmikro clone. Haven't really track tested the car with the cloned board, but at least I felt the steering/throttle response seems similar to the OEM board
I'm interested in dropping the dasMikro ASF MR03 clone board into an MR02 chassis. Does anyone know if I can just add the third wire to the pot and use the MR02 steering motor? If I have to use an MR03 servo motor, do I just have to figure out how to secure it in the chassis? Anyone done this before?
anyone have a wiring diagram to show where the switch/power wires go? for the servo and pot, is it a direct swap over in same order? FYI, i'm swapping out an MR-03 sport series 1 PCB for the clone ASF.
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated.
The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year. Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All!
Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»
Linear Mode
