I already found out that the 4pin header is different from the 4p ICS port on the ASF boards.
So these are the pinnings on the JST-ZH 4P connector:
1 - Headlight Gnd
2 - Headlight +
3 - Brake Gnd
4 - Brake +
With CH4 dial on the KT-531P you can change the flashing of the headlight (or no flashing at all).
I wonder if the rear lights become clearer when you apply brake, anyone tested, can confirm this?
I just found out this information today, after I killed the PCB of my MA03F
I love LEDs on my cars, the ASF board had brake lights as well on the 4P ICS connector, but only when you apply brake. I would prefer to have the rear light to illuminate when you release throttle.
[03/22/17] MZR was on vacation, didn't... : All kidding aside, the host experienced a bit of a server meltdown last week and efforts to restore the site to a new server took longer than anticipated.
The current server is temporary until - more»
[11/25/15] Did You Hear? Our Black... : Hey Racers,
We're getting started a bit early with our Black Friday sale this year. Generally we're not supporters of retailers opening early on Thanksgiving, but in our case, we're - more»
[06/30/15] shop.tinyrc.com: Have You... : Hey All!
Just a quick reminder to everyone that we post all of our shop.tinyrc.com Newletters here on the MZR Forum. If for some reason you miss them in your email inbox, you can always see the - more»